Chapter 15 Static Route
P-79X Series User’s Guide
158
Figure 95 Advanced > Static Route
The following table describes the labels in this screen.
15.2.1 Static Route Edit
Use this screen to configure the required information for a static route. Select a static route index
number and click Edit. The screen shown next appears.
Table 62 Advanced > Static Route
LABEL DESCRIPTION
# This is the number of an individual static route.
Active This field indicates whether the rule is active or not.
Clear the check box to disable the rule. Select the check box to enable it.
Name This is the name that describes or identifies this route.
Destination This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
Gateway This is the IP address of the gateway. The gateway is a router or switch on the
same network segment as the device's LAN or WAN port. The gateway helps
forward packets to their destinations.
Subnet Mask This parameter specifies the IP network subnet mask of the final destination.
Modify Click the Edit icon to go to the screen where you can set up a static route on the P-
79X.
Click the Remove icon to remove a static route from the P-79X. A window displays
asking you to confirm that you want to delete the route.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
To Next Page
Loading...
