Chapter 19 Remote Management
P-79X Series User’s Guide
183
• Use the P-79X’s LAN IP address when configuring from the LAN.
System Timeout
There is a default system management idle timeout of five minutes (three hundred seconds). The
P-79X automatically logs you out if the management session remains idle for longer than this
timeout period. The management session does not time out when a statistics screen is polling.
19.2 The WWW Screen
Use this screen to specify how to connect to the P-79X from a web browser, such as Internet
Explorer. You can also specify which IP addresses the access can come from.
Note: If you disable the WWW service in this screen, then the P-79X blocks all HTTP
connection attempts.
19.2.1 Configuring the WWW Screen
Click Advanced > Remote MGMT to display the WWW screen.
Figure 111 Advanced > Remote MGMT > WWW
The following table describes the labels in this screen.
Table 73 Advanced > Remote MGMT > WWW
LABEL DESCRIPTION
Port You may change the server port number for a service, if needed. However, you
must use the same port number in order to use that service for remote
management.
Access Status Select the interface(s) through which a computer may access the P-79X using
this service.
Secured Client IP A secured client is a “trusted” computer that is allowed to communicate with the
P-79X using this service.
Select All to allow any computer to access the P-79X using this service.
Choose Selected to just allow the computer with the IP address that you specify
to access the P-79X using this service.
To Next Page
Loading...
