Chapter 9 Wireless
UAG2100 User’s Guide
103
Each field is described in the following table.
9.3 AP Management Screen
Use this screen to manage all of the APs connected to the UAG. Click Configuration > Wireless >
AP Management to access this screen.
Figure 64 Configuration > Wireless > AP Management
Each field is described in the following table.
Table 45 Configuration > Wireless > Controller
LABEL DESCRIPTION
Registration
Type
Select Manual to add each AP to the UAG for management, or Always Accept to
automatically add APs to the UAG for management.
Note: Select the Manual option for managing a specific set of APs. This is recommended as the
registration mechanism cannot automatically differentiate between friendly and rogue
APs.
APs must be connected to the UAG by a wired connection or network.
Apply Click Apply to save your changes back to the UAG.
Reset Click Reset to return the screen to its last-saved settings.
Table 46 Configuration > Wireless > AP Management
LABEL DESCRIPTION
Edit Select an AP and click this button to edit its properties.
Remove Select an AP and click this button to remove it from the list.
Note: If in the Configuration > Wireless > Controller screen you set the Registration
Type to Always Accept, then as soon as you remove an AP from this list it
reconnects.
Reboot Select an AP and click this button to force it to restart.
# This field is a sequential value, and it is not associated with any entry.
IP Address This field displays the IP address of the AP.
MAC Address This field displays the MAC address of the AP.
To Next Page
Loading...
