Chapter 33 Addresses
UAG2100 User’s Guide
315
Figure 206 Configuration > Object > Address > Address
The following table describes the labels in this screen. See Section 33.2.1 on page 315 for more
information as well.
33.2.1 Address Add/Edit Screen
The Configuration > Object > Address Add/Edit screen allows you to create a new address or
edit an existing one. To access this screen, go to the Address screen (see Section 33.2 on page
314), and click either the Add icon or an Edit icon in the Configuration section.
Figure 207 IPv4 Address Configuration > Add/Edit
Table 153 Configuration > Object > Address > Address
LABEL DESCRIPTION
Configuration
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The UAG confirms you want to remove it
before doing so.
Object Reference Select an entry and click Object Reference to open a screen that shows which settings
use the entry. See Section 10.3.2 on page 117 for an example.
# This field is a sequential value, and it is not associated with a specific address.
Name This field displays the configured name of each address object.
Type This field displays the type of each address object. “INTERFACE” means the object uses
the settings of one of the UAG’s interfaces.
IPv4 Address This field displays the IPv4 addresses represented by each address object. If the object’s
settings are based on one of the UAG’s interfaces, the name of the interface displays first
followed by the object’s current address settings.
To Next Page
Loading...
