ZyXEL Communications UAG2100 - 40.7.6 Customizing the WWW Login Page

Chapter 40 System
UAG2100 User’s Guide
372
The following table describes the labels in this screen.
40.7.6 Customizing the WWW Login Page
Click Configuration > System > WWW > Login Page to open the Login Page screen. Use this
screen to customize the Web Configurator login screen. You can also customize the page that
displays after an access user logs into the Web Configurator to access network services like the
Internet. See Chapter 31 on page 285 for more on access user accounts.
Table 188 Configuration > System > Service Control Rule > Edit
LABEL DESCRIPTION
Create new
Object
Use this to configure any new settings objects that you need to use in this screen.
Address Object Select ALL to allow or deny any computer to communicate with the UAG using this service.
Select a predefined address object to just allow or deny the computer with the IP address
that you specified to access the UAG using this service.
Zone Select ALL to allow or prevent any UAG zones from being accessed using this service.
Select a predefined UAG zone on which a incoming service is allowed or denied.
Action Select Accept to allow the user to access the UAG from the specified computers.
Select Deny to block the user’s access to the UAG from the specified computers.
OK Click OK to save your customized settings and exit this screen.
Cancel Click Cancel to exit this screen without saving