Chapter 25 Firewall
UAG2100 User’s Guide
239
25.3 The Session Control Screen
Click Configuration > Firewall > Session Control to display the Firewall Session Control
screen. Use this screen to limit the number of concurrent NAT/firewall sessions a client can use. You
can apply a default limit for all users and individual limits for specific users, addresses, or both. The
individual limit takes priority if you apply both.
Figure 159 Configuration > Firewall > Session Limit
Access Use the drop-down list box to select what the firewall is to do with packets that match this
rule.
Select deny to silently discard the packets without sending a TCP reset packet or an ICMP
destination-unreachable message to the sender.
Select reject to deny the packets and send a TCP reset packet to the sender. Any UDP
packets are dropped without sending a response packet.
Select allow to permit the passage of the packets.
Log Select whether to have the UAG generate a log (log), log and alert (log alert) or not (no)
when the rule is matched. See Chapter 41 on page 395 for more on logs.
OK Click OK to save your customized settings and exit this screen.
Cancel Click Cancel to exit this screen without saving.
Table 109 Configuration > Firewall > Add (continued)
LABEL DESCRIPTION
To Next Page
Loading...
