Chapter 40 System
UAG2100 User’s Guide
366
Figure 241 Configuration > System > DNS > MX Record Add
The following table describes the labels in this screen.
40.6.10 Adding a DNS Service Control Rule
Click the Add icon in the Service Control table to add a service control rule.
Figure 242 Configuration > System > DNS > Service Control Rule Add
The following table describes the labels in this screen.
Table 185 Configuration > System > DNS > MX Record Add
LABEL DESCRIPTION
Domain Name Enter the domain name where the mail is destined for.
IP Address/FQDN Enter the IP address or Fully-Qualified Domain Name (FQDN) of a mail server that handles
the mail for the domain specified in the field above.
OK Click OK to save your customized settings and exit this screen.
Cancel Click Cancel to exit this screen without saving
Table 186 Configuration > System > DNS > Service Control Rule Add
LABEL DESCRIPTION
Create new
Object
Use this to configure any new settings objects that you need to use in this screen.
Address Object Select ALL to allow or deny any computer to send DNS queries to the UAG.
Select a predefined address object to just allow or deny the computer with the IP address
that you specified to send DNS queries to the UAG.
Zone Select ALL to allow or prevent DNS queries through any zones.
Select a predefined zone on which a DNS query to the UAG is allowed or denied.
Action Select Accept to have the UAG allow the DNS queries from the specified computer.
Select Deny to have the UAG reject the DNS queries from the specified computer.
To Next Page
Loading...
