Chapter 21 IP/MAC Binding
UAG2100 User’s Guide
204
Figure 128 Configuration > Network > IP/MAC Binding > Edit
The following table describes the labels in this screen.
Table 94 Configuration > Network > IP/MAC Binding > Edit
LABEL DESCRIPTION
IP/MAC Binding Settings
Interface
Name
This field displays the name of the interface within the UAG and the interface’s IP address
and subnet mask.
Enable IP/MAC
Binding
Select this option to have this interface enforce links between specific IP addresses and
specific MAC addresses. This stops anyone else from manually using a bound IP address
on another device connected to this interface. Use this to make use only the intended
users get to use specific IP addresses.
Enable Logs
for IP/MAC
Binding
Violation
Select this option to have the UAG generate a log if a device connected to this interface
attempts to use an IP address not assigned by the UAG.
Static DHCP
Bindings
This table lists the bound IP and MAC addresses. The UAG checks this table when it
assigns IP addresses. If the computer’s MAC address is in the table, the UAG assigns the
corresponding IP address. You can also access this table from the interface’s edit screen.
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify
the entry’s settings.
Remove To remove an entry, select it and click Remove. The UAG confirms you want to remove it
before doing so.
# This is the index number of the static DHCP entry.
IP Address This is the IP address that the UAG assigns to a device with the entry’s MAC address.
MAC Address This is the MAC address of the device to which the UAG assigns the entry’s IP address.
Description This helps identify the entry.
OK Click OK to save your changes back to the UAG.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
