Chapter 36 AAA Server
UAG2100 User’s Guide
330
Figure 219 Configuration > Object > AAA Server > RADIUS > Add
The following table describes the labels in this screen.
Table 165 Configuration > Object > AAA Server > RADIUS > Add
LABEL DESCRIPTION
Name Enter a descriptive name (up to 63 alphanumerical characters) for identification purposes.
Description Enter the description of each server, if any. You can use up to 60 printable ASCII
characters.
Server Address Enter the address of the RADIUS server.
Authentication
Port
Specify the port number on the RADIUS server to which the UAG sends authentication
requests. Enter a number between 1 and 65535.
Backup Server
Address
If the RADIUS server has a backup server, enter its address here.
Backup
Authentication
Port
Specify the port number on the RADIUS server to which the UAG sends authentication
requests. Enter a number between 1 and 65535.
Timeout Specify the timeout period (between 1 and 300 seconds) before the UAG disconnects from
the RADIUS server. In this case, user authentication fails.
Search timeout occurs when either the user information is not in the RADIUS server or the
RADIUS server is down.
NAS IP Address If the RADIUS server requires the UAG to provide the Network Access Server (NAS) IP
address attribute with a specific value, enter it here.
Case-sensitive
User Names
Select this if the server checks the case of the usernames.
To Next Page
Loading...
