ZyXEL Communications VMG3925-B10A - The DNS Route Add Screen; The Policy Route Screen

Chapter 9 Routing
VMG3925-B10A User’s Guide
135
9.3.1 The DNS Route Add Screen
You can manually add the VMG’s DNS route entry. Click Add New DNS Route in the Network
Setting > Routing > DNS Route screen. The screen shown next appears.
Figure 63 DNS Route Add
The following table describes the labels in this screen.
9.4 The Policy Route Screen
Traditionally, routing is based on the destination address only and the VMG takes the shortest path
to forward a packet. Policy route allows the VMG to override the default routing behavior and alter
the packet forwarding based on the policy defined by the network administrator. Policy-based
routing is applied to outgoing packets, prior to the normal routing.
WAN Interface This is the WAN connection through which the VMG forwards DNS requests for this domain
name.
Subnet Mask This is the subnet mask of the DNS route entry.
Modify Click the Edit icon to modify the DNS route.
Click the Delete icon to delete the DNS route.
Table 40 Network Setting > Routing > DNS Route (continued)
LABEL DESCRIPTION
Table 41 DNS Route Add
LABEL DESCRIPTION
Active Select Enable to activate this DNS route.
Domain Name Enter the domain name of the DNS route entry.
Subnet Mask Enter the subnet mask of the DNS route entry.
WAN Interface Select the WAN connection through which the VMG forwards DNS requests for this domain
name. WWAN means the wireless 3G interface.
OK Click this to save your changes.
Cancel Click this to exit this screen without saving any changes.