VMG3925-B10A User’s Guide
235
CHAPTER 31
Remote Management
31.1 Overview
Remote management controls through which interface(s), which services can access the VMG.
Note: The VMG is managed using the Web Configurator.
31.2 The Remote MGMT Screen
Use this screen to configure through which interface(s), which services can access the VMG. You
can also specify the port numbers the services must use to connect to the VMG. Click Maintenance
> Remote MGMT to open the following screen.
Figure 142 Maintenance > Remote MGMT
The following table describes the fields in this screen.
Table 113 Maintenance > Remote MGMT
LABEL DESCRIPTION
WAN Interface
used for
services
Select Any_WAN to have the VMG automatically activate the remote management service
when any WAN connection is up.
Select Multi_WAN and then select one or more WAN connections to have the VMG activate
the remote management service when the selected WAN connections are up.
service This is the service you may use to access the VMG.
LAN/WLAN Select the Enable check box for the corresponding services that you want to allow access to
the VMG from the LAN/WLAN.
WAN Select the Enable check box for the corresponding services that you want to allow access to
the VMG from all WAN connections.
To Next Page
Loading...
