ZyXEL Communications VMG3925-B10A - Add;Edit a Qos Policer

Chapter 10 Quality of Service (QoS)
VMG3925-B10A User’s Guide
151
10.7.1 Add/Edit a QoS Policer
Click Add New Policer in the Policer Setup screen or the Edit icon next to a policer to show the
following screen.
Figure 75 Policer Setup: Add/Edit
The following table describes the labels in this screen.
Status This field displays whether the policer is active or not. A yellow bulb signifies that this
policer is active. A gray bulb signifies that this policer is not active.
Name This field displays the descriptive name of this policer.
Regulated
Classes
This field displays the name of a QoS classifier
Meter Type This field displays the type of QoS metering algorithm used in this policer.
Rule These are the rates and burst sizes against which the policer checks the traffic of the
member QoS classes.
Action This shows the how the policer has the VMG treat different types of traffic belonging to the
policer’s member QoS classes.
Modify Click the Edit icon to edit the policer.
Click the Delete icon to delete an existing policer. Note that subsequent rules move up by
one when you take this action.
Table 52 Network Setting > QoS > Policer Setup (continued)
LABEL DESCRIPTION
Table 53 Policer Setup: Add/Edit
LABEL DESCRIPTION
Active Select enable or disable this policer.
Name Enter the descriptive name of this policer.