VMG3925-B10A User’s Guide
59
CHAPTER 6
Broadband
6.1 Overview
This chapter discusses the VMG’s Broadband screens. Use these screens to configure your VMG for
Internet access.
A WAN (Wide Area Network) connection is an outside connection to another network or the
Internet. It connects your private networks, such as a LAN (Local Area Network) and other
networks, so that a computer in one location can communicate with computers in other locations.
Figure 16 LAN and WAN
6.1.1 What You Can Do in this Chapter
•Use the Broadband screen to view, remove or add a WAN interface. You can also configure the
WAN settings on the VMG for Internet access (Section 6.2 on page 63).
•Use the 3G Backup screen to configure 3G WAN connection (Section 6.3 on page 71).
•Use the Advanced screen to enable or disable PTM over ADSL, Annex M/Annex J, and DSL PhyR
functions (Section 6.4 on page 75).
•Use the 802.1x screen to view and configure the IEEE 802.1X settings on the VMG (Section 6.5
on page 78).
Table 6 WAN Setup Overview
LAYER-2 INTERFACE INTERNET CONNECTION
CONNECTION
DSL LINK
TYPE
MODE ENCAPSULATION CONNECTION SETTINGS
ADSL/VDSL
over PTM
N/A Routing PPPoE PPP information, IPv4/IPv6 IP
address, routing feature, DNS
server, VLAN, QoS, and MTU
IPoE IPv4/IPv6 IP address, routing
feature, DNS server, VLAN, QoS,
and MTU
Bridge N/A VLAN and QoS
To Next Page
Loading...
