Chapter 31 Remote Management
VMG3925-B10A User’s Guide
236
31.3 The Trust Domain Screen
Use this screen to view a list of public IP addresses which are allowed to access the VMG through
the services configured in the Maintenance > Remote MGMT screen. Click Maintenance >
Remote MGMT > Turst Domain to open the following screen.
Note: If this list is empty, all public IP addresses can access the VMG from the WAN
through the specified services.
Figure 143 Maintenance > Remote MGMT > Trust Domain
The following table describes the fields in this screen.
31.3.1 The Add Trust Domain Screen
Use this screen to configure a public IP address which is allowed to access the VMG. Click the Add
Trust Domain button in the Maintenance > Remote MGMT > Turst Domain screen to open the
following screen.
Trust Domain If you only want certain WAN connections to have access to to the VMG using the
corresponding services, then clear WAN, select Trust Domain and configure the allowed IP
address(es) in the Trust Domain screen.
Port You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Apply Click Apply to save your changes back to the VMG.
Cancel Click Cancel to restore your previously saved settings.
Table 113 Maintenance > Remote MGMT (continued)
LABEL DESCRIPTION
Table 114 Maintenance > Remote MGMT > Trust Domain
LABEL DESCRIPTION
Add Trust
Domain
Click this to add a trusted host IP address.
IP Address This field shows a trusted host IP address.
Delete Click the Delete icon to remove the trust IP address.
To Next Page
Loading...
