Chapter 17 Firewall
VMG3925-B10A User’s Guide
197
17.4 The Access Control Screen
Click Security > Firewall > Access Control to display the following screen. This screen displays a
list of the configured incoming or outgoing filtering rules.
Figure 111 Security > Firewall > Access Control
The following table describes the labels in this screen.
17.4.1 Add/Edit an ACL Rule
Click Add new ACL rule or the Edit icon next to an existing ACL rule in the Access Control
screen. The following screen displays.
OK Click OK to save your changes.
Cancel Click Cancel to exit this screen without saving.
Table 83 Security > Firewall > Protocol: Add/Edit (continued)
LABEL DESCRIPTION
Table 84 Security > Firewall > Access Control
LABEL DESCRIPTION
Add New ACL
Rule
Click this to go to add a filter rule for incoming or outgoing IP traffic.
# This is the index number of the entry.
Name This displays the name of the rule.
Src IP This displays the source IP addresses to which this rule applies. Please note that a blank
source address is equivalent to Any.
Dst IP This displays the destination IP addresses to which this rule applies. Please note that a
blank destination address is equivalent to Any.
Service This displays the transport layer protocol that defines the service and the direction of traffic
to which this rule applies.
Action This field displays whether the rule silently discards packets (DROP), discards packets and
sends a TCP reset packet or an ICMP destination-unreachable message to the sender
(REJECT) or allows the passage of packets (ACCEPT).
Modify Click the Edit icon to edit the rule.
Click the Delete icon to delete an existing rule. Note that subsequent rules move up by one
when you take this action.
Click the Move To icon to change the order of the rule. Enter the number in the # field.
To Next Page
Loading...
