VMG3925-B10A User’s Guide
200
CHAPTER 18
MAC Filter
18.1 Overview
You can configure the VMG to permit access to clients based on their MAC addresses in the MAC
Filter screen. This applies to wired and wireless connections. Every Ethernet device has a unique
MAC (Media Access Control) address. The MAC address is assigned at the factory and consists of six
pairs of hexadecimal characters, for example, 00:A0:C5:00:00:02. You need to know the MAC
addresses of the devices to configure this screen.
18.2 The MAC Filter Screen
Use this screen to allow wireless and LAN clients access to the VMG. Click Security > MAC Filter.
The screen appears as shown.
Figure 114 Security > MAC Filter
To Next Page
Loading...
