ZyXEL Communications VMG3925-B10A - Add;Edit Policy Route

Chapter 9 Routing
VMG3925-B10A User’s Guide
137
9.4.1 Add/Edit Policy Route
Click Add New Policy Route in the Policy Route screen or click the Edit icon next to a policy. Use
this screen to configure the required information for a policy route.
Figure 65 Network Setting > Routing > Policy Route: Add/Edit
The following table describes the labels in this screen.
Table 43 Network Setting > Routing > Policy Route: Add/Edit
LABEL DESCRIPTION
Active Select Enable to activate this policy route.
Route Name Enter a descriptive name of up to 8 printable English keyboard characters, not including
spaces.
Source IP
Address
Enter the source IP address.
Source Subnet
Mask
Enter the source subnet mask address.
Protocol Select the transport layer protocol (TCP or UDP).
Source Port Enter the source port number.
Source MAC Enter the source MAC address.
Source
Interface
Type the name of the interface from which the matched traffic is sent.
WAN Interface Select a WAN interface through which the traffic is sent. You must have the WAN
interface(s) already configured in the Broadband screens.
OK Click OK to save your changes.
Cancel Click Cancel to exit this screen without saving.