Chapter 7 Wireless
VMG3925-B10A User’s Guide
89
In order to configure and enable WEP encryption, click Network Setting > Wireless to display the
General screen, then select Basic as the security level.
Figure 31 Wireless > General: Basic (WEP)
The following table describes the labels in this screen.
7.2.3 More Secure (WPA(2)-PSK)
The WPA-PSK security mode provides both improved data encryption and user authentication over
WEP. Using a Pre-Shared Key (PSK), both the VMG and the connecting client share a common
Table 18 Wireless > General: Basic (WEP)
LABEL DESCRIPTION
Security Level Select Basic to enable WEP data encryption.
Security Mode This shows WEP when you set Security Level to Basic.
Generate
password
automatically
Select this option to have the VMG automatically generate a password. The password field
will not be configurable when you select this option.
Password 1~4 The password (WEP keys) are used to encrypt data. Both the VMG and the wireless stations
must use the same password (WEP key) for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal characters
("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal characters
("0-9", "A-F").
You must configure at least one password, only one password can be activated at any one
time.
more.../less Click more... to show more fields in this section. Click hide to hide them.
password
unmask
Select password unmask to show your entered password in plain text.
WEP Encryption Select 64-bits or 128-bits.
This dictates the length of the security key that the network is going to use.
To Next Page
Loading...
