Chapter 7 Wireless
VMG3925-B10A User’s Guide
94
pairs of hexadecimal characters, for example, 00:A0:C5:01:23:45. You need to know the MAC
addresses of the devices to configure this screen.
Use this screen to view your VMG’s MAC filter settings and add new MAC filter rules. Click Network
Setting > Wireless > MAC Authentication. The screen appears as shown.
Figure 35 Wireless > MAC Authentication
The following table describes the labels in this screen.
7.5 The WPS Screen
Use this screen to configure WiFi Protected Setup (WPS) on your VMG.
Table 22 Wireless > MAC Authentication
LABEL DESCRIPTION
SSID Select the SSID for which you want to configure MAC filter settings.
MAC Restrict
Mode
Define the filter action for the list of MAC addresses in the MAC Address table.
Select Disable to turn off MAC filtering.
Select Deny to block access to the VMG. MAC addresses not listed will be allowed to access
the VMG.
Select Allow to permit access to the VMG. MAC addresses not listed will be denied access to
the VMG.
Add new MAC
address
Click this if you want to add a new MAC address entry to the MAC filter list below.
Enter the MAC addresses of the wireless devices that are allowed or denied access to the
VMG in these address fields. Enter the MAC addresses in a valid MAC address format, that
is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
# This is the index number of the entry.
MAC Address This is the MAC addresses of the wireless devices that are allowed or denied access to the
VMG.
Modify Click the Delete icon to remove the entry.
Click the Edit icon to change the MAC address.
Apply Click Apply to save your changes.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
