ZyXEL Communications VMG3925-B10A - Page 45

Chapter 4 Tutorials
VMG3925-B10A User’s Guide
45
network) to computer B (in N2 network), the traffic is sent to the VMG’s WAN default gateway by
default. In this case, B will never receive the traffic.
You need to specify a static routing rule on the VMG to specify R as the router in charge of
forwarding traffic to N2. In this case, the VMG routes traffic from A to R and then R routes the
traffic to B.
This tutorial uses the following example IP settings:
Table 4 IP Settings in this Tutorial
DEVICE / COMPUTER IP ADDRESS
The VMG’s WAN 172.16.1.1
The VMG’s LAN 192.168.1.1
IP Type IPv4
Use Interface VDSL/ppp1.1
A 192.168.1.34
R’s N1 192.168.1.253
N2
B
N1
A
R
N2
B
N1
A
R