Chapter 18 Port Authentication
XGS2210 Series User’s Guide
192
Figure 149 Advanced Application > Port Authentication > 802.1x (Stacking mode)
The following table describes the labels in this screen.
Table 74 Advanced Application > Port Authentication > 802.1x
LABEL DESCRIPTION
Active Select this check box to permit 802.1x authentication on the Switch.
Note: You must first enable 802.1x authentication on the Switch before configuring it
on each port.
Slot (Stacking
mode)
This field appears only in stacking mode. Click the drop-down list to choose the slot number of
the Switch in a stack.
Port (Standalone
or stacking
mode)
This field displays the port number. In stacking mode, the first number is the slot ID and the
second is the port number. * means all ports.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Active Select this to permit 802.1x authentication on this port. You must first allow 802.1x
authentication on the Switch before configuring it on each port.
To Next Page
Loading...
