Chapter 36 Anti-Arpscan
XGS2210 Series User’s Guide
373
36.5 Anti-Arpscan Configure
Use this screen to enable Anti-Arpscan, set port and host thresholds as well as configure ports to be
trusted or untrusted. To open this screen, click Advanced Application > Anti-Arpscan > Configure.
Figure 287 Advanced Application > Anti-Arpscan > Configure (Standalone mode)
Clear Click this to clear the fields above.
Index This field displays a sequential number for each trusted host.
Name This field displays the name of the trusted host.
Host IP This field displays the IP address of the trusted host.
Mask This field displays the subnet mask of the trusted host.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Select an entry checkbox and click Delete to remove the specified entry.
Cancel Click this to clear the check boxes above.
Table 164 Advanced Application > Anti-Arpscan > Trust Host (continued)
LABEL DESCRIPTION
To Next Page
Loading...
