Chapter 8 Basic Setting
XGS2210 Series User’s Guide
66
8.2.1 System Information Stacking Hardware Monitor
Click a slot number in the System Info screen to display more detailed hardware information on a
Switch.
Figure 47 Basic Setting > System Info > Hardware Monitor (Stacking Mode)
The following table describes the labels in this screen.
Status Normal indicates that the voltage is within an acceptable operating range at this point;
otherwise Error is displayed.
Hardware Status (Stacking Mode)
Slot This number identifies the Switch in the stack. Click the number to see more detailed information
on the Switch.
Name This is the system name of the Switch in the stack.
Voltage This shows if the power supply voltage sensor is within normal tolerance range.
Temperatur
e
This shows if the temperature sensors on the Switch printed circuit board are within normal
tolerance range.
Fan This shows if the fan sensors are within normal tolerance range.
Table 11 Basic Setting > System Info (Standalone and Stacking Modes) (continued)
LABEL DESCRIPTION
Table 12 Basic Setting > System Info > Hardware Monitor (Stacking Mode)
LABEL DESCRIPTION
SLOT This number identifies the Switch in the stack.
Temperature Unit The Switch has temperature sensors that are capable of detecting and reporting if the
temperature rises above the threshold. You may choose the temperature unit (Centigrade or
Fahrenheit) in this field.
Temperature BOARD, PHY, CPU and MAC refer to the location of the temperature sensors on the Switch
printed circuit board.
Current This shows the current temperature at this sensor.
MAX This field displays the maximum temperature measured at this sensor.
MIN This field displays the minimum temperature measured at this sensor.
To Next Page
Loading...
