Chapter 8 Basic Setting
XGS2210 Series User’s Guide
75
8.7 Port Setup
Use this screen to configure Switch port settings. Click Basic Setting > Port Setup in the navigation panel
to display the configuration screen.
Figure 54 Basic Setting > Port Setup (Standalone mode)
Type This field displays the type of IP address status.
Select an entry’s check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Delete Click Delete to remove the selected entry from the summary table.
Note: Deleting all IP subnets locks you out of the Switch.
Cancel Click Cancel to clear the check boxes.
Table 18 Basic Setting > IP Setup > IP Configuration (continued)
LABEL DESCRIPTION
To Next Page
Loading...
