Chapter 8 Basic Setting
XGS2210 Series User’s Guide
80
8.8.1 PoE Time Range Status
Use this screen to see whether PoE is scheduled to be enabled on a port.
Click the PoE Time Range Status link in the Basic Setting > PoE Status screen. The following screen opens.
Figure 59 Basic Setting > PoE Setup > PoE Time Range Status (Standalone mode)
State This field shows which ports can receive power from the Switch. You can set this in Section 8.8.2
on page 81.
• Disable - The PD connected to this port cannot get power supply.
• Enable - The PD connected to this port can receive power.
Class This shows the power classification of the PD.
This is a number from 0 to 4, where each value represents a range of power (W) and power
current (mA) that the PD requires to function. The ranges are as follows.
• Class 0 - Default, 0.44 to 12.94
• Class 1 - Optional, 0.44 to 3.84
• Class 2 - Optional, 3.84 to 6.49
• Class 3 - Optional, 6.49 to 12.95
• Class 4 - Reserved (PSEs classify as Class 0) in a Switch that supports IEEE 802.3af only.
Optional, 12.95 to 25.50 in a Switch that supports IEEE 802.3at.
PD Priority When the total power requested by the PDs exceeds the total PoE power budget on the Switch,
you can set the PD priority to allow the Switch to provide power to ports with higher priority first.
• Critical has the highest priority.
• High has the Switch assign power to the port after all critical priority ports are served.
• Low has the Switch assign power to the port after all critical and high priority ports are
served.
Power-Up This field displays the PoE standard the Switch uses to provide power on this port.
Consuming
Power (mW)
This field displays the current amount of power consumed by the PD from the Switch on this port.
Max Power
(mW)
This field displays the maximum amount of power the PD could use from the Switch on this port.
Table 20 Basic Setting > PoE Status (continued)
LABEL DESCRIPTION
To Next Page
Loading...
