Chapter 26 IP Source Guard
XGS2210 Series User’s Guide
280
26.10.1 ARP Inspection Port Configure
Use this screen to specify whether ports are trusted or untrusted ports for ARP inspection. You can also
specify the maximum rate at which the Switch receives ARP packets on each untrusted port. To open
this screen, click Advanced Application > IP Source Guard > IPv4 Source Guard Setup > ARP Inspection >
Configure > Port.
Figure 209 Advanced Application > IP Source Guard > IPv4 Source Guard Setup > ARP Inspection >
Configure > Port (Standalone mode)
Log interval Enter how often (1-86400 seconds) the Switch sends a batch of syslog messages to the
syslog server. Enter 0 if you want the Switch to send syslog messages immediately. See
Syslog rate for an example of the relationship between Syslog rate and Log interval.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel Click this to reset the values in this screen to their last-saved values.
Table 118 Advanced Application > IP Source Guard > IPv4 Source Guard Setup > ARP Inspection >
Configure (continued)
LABEL DESCRIPTION
To Next Page
Loading...
