Chapter 26 IP Source Guard
XGS2210 Series User’s Guide
272
Figure 202 Advanced Application > IP Source Guard > IPv4 Source Guard Setup > DHCP Snooping >
Configure > Port (Stacking mode)
The following table describes the labels in this screen.
Table 112 Advanced Application > IP Source Guard > IPv4 Source Guard Setup > DHCP Snooping >
Configure > Port
LABEL DESCRIPTION
Slot (Stacking mode) This field appears only in stacking mode. Click the drop-down list to choose the slot
number of the Switch in a stack.
Port (Standalone or
stacking mode)
This field displays the port number. In stacking mode, the first number is the slot ID and
the second is the port number. If you configure the * port, the settings are applied to all
of the ports.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row
first to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make
them.
To Next Page
Loading...
