Chapter 29 sFlow
XGS2210 Series User’s Guide
309
Figure 236 Advanced Application > sFlow (Stacking mode)
The following table describes the labels in this screen.
Table 130 Advanced Application > sFlow
LABEL DESCRIPTION
Active Select this to enable the sFlow agent on the Switch.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Slot (Stacking
mode)
This field appears only in stacking mode. Click the drop-down list to choose the slot number of
the Switch in a stack.
Port
(Standalone or
stacking mode)
This field displays the port number. In stacking mode, the first number is the slot ID and the
second is the port number. * means all ports.
To Next Page
Loading...
