Chapter 39 ZULD
XGS2210 Series User’s Guide
395
Probe Time Type the length of time that ZULD waits before declaring that a link is unidirectional. When the
probe time expires, and one port (either on the Switch or the connected device) still has not
received an OAMPDU, then ZULD declares that the link is unidirectional.
The allowed time range is from 5-65535 seconds.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click this to reset the values in this screen to their last-saved values.
Table 173 Advanced Application > ZULD > Configuration (continued)
LABEL DESCRIPTION
To Next Page
Loading...
