Chapter 1 Introducing the XMG
XMG3512-B10A User’s Guide
20
Internet
Green On The XMG has an IP connection but no traffic.
Your device has a WAN IP address (either static or assigned by a DHCP
server), PPP negotiation was successfully completed (if used) and the DSL
connection is up.
Blinking The XMG is sending or receiving IP traffic.
Off There is no Internet connection or the gateway is in bridged mode.
Red On The XMG attempted to make an IP connection but failed. Possible causes
are no response from a DHCP server, no PPPoE response, PPPoE
authentication failed.
WAN
Green On The XMG has a successful 10/100/1000 Mbps Ethernet connection on the
WAN.
Blinking The XMG is sending or receiving data to/from the WAN at 10/100/1000
Mbps.
Off There is no Ethernet connection on the WAN.
Ethernet 1~4
Green On The XMG has a successful 1000 Mbps Ethernet connection with a device on
the Local Area Network (LAN).
Blinking The XMG is sending or receiving data to/from the LAN at 1000 Mbps.
Off The XMG does not have an Ethernet connection with the LAN.
USB
Green On The XMG recognizes a USB connection through the USB slot.
Blinking The XMG is sending/receiving data to /from the USB device connected to
it.
Off The XMG does not detect a USB connection through the USB slot.
WiFi 2.4G
Green On The 2.4 GHz wireless network is activated.
Blinking The XMG is communicating with 2.4 GHz wireless clients.
Amber On The XMG is setting up a WPS connection with a 2.4GHz wireless client using
the WPS Method 3.
To learn more about each WPS method see Section 7.5 on page 93 .
Blinking The XMG is setting up a WPS connection with a 2.4 GHz wireless client using
the WPS Methods 1 or 2.
To learn more about each WPS method see Section 7.5 on page 93 .
Off The 2.4 GHz wireless network is not activated.
WiFi 5G
Green On The 5 GHz wireless network is activated.
Blinking The XMG is communicating with 5 GHz wireless clients.
Amber On The XMG is setting up a WPS connection with a 5 GHz wireless client using
the WPS Method 3.
To learn more about each WPS method see Section 7.5 on page 93 .
Blinking The XMG is setting up a WPS connection with a 5 GHz wireless client using
the WPS Methods 1 or 2.
To learn more about each WPS method see Section 7.5 on page 93 .
Off The 5 GHz wireless network is not activated.
WPS
Amber On The 2.4 Ghz or 5 GHz wireless network and WPS are enabled.
Off Both 2.4 Ghz or 5 GHz wireless network and WPS are disabled.
Table 1 LED Descriptions (continued)
LED COLOR STATUS DESCRIPTION
To Next Page
Loading...
