ZyXEL Communications ZyWALL 310 - How to Configure Site-To-Site Ipsec VPN with Fortigate; Set up the Ipsec VPN Tunnel on the Zywall;Usg

169/749
www.zyxel.com
How to Configure Site-to-site IPSec VPN with FortiGate
This example shows how to use the VPN Setup Wizard to create a site-to-site VPN
between a ZYWALL/USG and a FortiGate router. The example instructs how to
configure the VPN tunnel between each site. The example instructs how to
configure the VPN tunnel between each site. When the VPN tunnel is configured,
each site can be accessed securely.
ZyWALL Site-to-site IPSec VPN with FortiGate Connected
Set Up the IPSec VPN Tunnel on the ZyWALL/USG
In the ZyWALL/USG, go to CONFIGURATION >Quick Setup > VPN Setup Wizard, use
the VPN Settings wizard to create a VPN rule that can be used with the FortiGate.
Click Next.
Quick Setup > VPN Setup Wizard > Welcome
Note: All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This
example was tested using USG310 (Firmware Version: ZLD 4.25) and FortiGate 100D
(Firmware Version: Forti OS 5.2.1).