ZyXEL Communications ZyWALL 310 - How to Let a Server Use the same Public IP Address as the WAN Interface Using the Bridge Interface

670/749
www.zyxel.com
How to Let a Server Use the Same Public IP Address as the
WAN Interface Using the Bridge Interface
This is an example of using ZyWALL/USG to configure an internal server in bridge
mode without applying network address translation (NAT). The Internet users can
reach this server directly by its public IP address.
ZyWALL/USG with Bridge Interface Example
Note: All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This
example was tested using USG310 (Firmware Version: ZLD 4.25).