ZyXEL Communications ZyWALL 310 - Set up the AP Management on the Zywall;Usg

679/749
www.zyxel.com
Set Up the AP Management on the ZyWALL/USG
In the ZyWALL/USG, go to CONFIGURATION > Wireless > Controller > Configuration,
set Registration Type to Manual. This is recommended as the registration
mechanism cannot automatically differentiate between friendly and rogue APs.
CONFIGURATION > Wireless > Controller > Configuration
Connect the ZyXEL AP unit to the lan interface.
Go to MONITOR > Wireless > AP Information > AP List and the ZyXEL AP is listed. A
green question mark displays in the Status column since the AP is not yet managed
by the ZyWALL/USG. Select the listed AP and click Add to Mgnt AP List on the upper
bar.
CONFIGURATION > Wireless > AP Information > AP List
Go to CONFIGURATION > Object > AP Profile > SSID > SSID List to configure a name
to identify the SSID.
CONFIGURATION > Object > AP Profile > SSID > SSID List
Note: The APs may take few minutes to appear in the AP List.