ZyXEL Communications ZyWALL 310 - Enable the Ipv6 on the Zywall;Usg; Set up the WAN Ipv6 Interface on the Zywall;Usg

711/749
www.zyxel.com
Enable the IPv6 on the ZyWALL/USG
In the ZyWALL/USG, go to CONFIGURATION > System > IPv6 > Global Setting, select
the Enable IPv6 and click Apply at the bottom of the screen.
CONFIGURATION > System > IPv6 > Global Setting
Set Up the WAN IPv6 Interface on the ZyWALL/USG
In the ZyWALL/USG, go to CONFIGURATION > Network > Interface > Ethernet >
wan1. Select Enable Interface and Enable IPv6. Select Enable Stateless Address
Auto-configuration (SLAAC). Click OK.