ZyXEL Communications ZyWALL 310 - Set up the Policy Route on the Zywall;Usg

724/749
www.zyxel.com
CONFIGURATION > Network > Interface > Tunnel
Set Up the Policy Route on the ZyWALL/USG
In the ZyWALL/USG, go to CONFIGURATION > Network > Routing > IPv6
Configuration > Add, click Create New Object to create an IPv6 address object
with the address prefix of 2002:7a64:dcee:1::/64. Select Enable. Select the address
object you just created in the Source Address field. Select any in the Destination
Address field. Select Interface as the next-hop type and then tunnel0 as the
interface. Click OK.