1-20
Configuring Traffic Shaping
Refer to Traffic Policing and Traffic Shaping for information about traffic shaping.
Configuration prerequisites
z The queue for which traffic shaping is to be performed has been determined.
z The maximum traffic rate and the burst size have been determined.
z The port where traffic shaping is to be configured has been determined.
Configuration procedure
Follow these steps to configure traffic shaping:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Configure traffic shaping
traffic-shape [ queue
queue-id ] max-rate
burst-size
Required
Disabled by default.
Traffic shaping can be configured in
one of the following two modes:
z Without queue queue-id specified,
traffic shaping applies to all traffic.
z With queue queue-id specified,
traffic shaping applies to traffic in
the specified queue.
Configuration example
# Configure traffic shaping for all the traffic to be transmitted through GigabitEthernet 1/0/1, with the
maximum traffic rate being 640 kbps and the burst size being 16 kbytes.
<Sysname> system-view
[Sysname] interface GigabitEthernet1/0/1
[Sysname-GigabitEthernet1/0/1] traffic-shape 640 16
Configuring Queue Scheduling
Refer to Queue Scheduling for information about queue scheduling.
Configuration prerequisites
The queue scheduling algorithm to be used and the related parameters have been determined.
Configuration procedures
1) Configuring SP queuing
Follow these steps to configure SP queuing:
To do… Use the command… Remarks
Enter system view
system-view
—
To Next Page
Loading...
