2-5
z A smart link/monitor link group with members cannot be deleted. A smart link group as a monitor
link group member cannot be deleted.
z The smart link/monitor link function and the remote port mirroring function are incompatible with
each other.
z If a single port is specified as a smart link/monitor link group member, do not use the lacp enable
command on the port or add the port to another dynamic link aggregation group because doing so
will cause the port to become an aggregation group member.
z Using the copy command on a port does not copy the smart link/monitor link group member
information configured on the port to any other port.
Displaying Monitor Link Configuration
To do… Use the command… Remarks
Display the information about
one or all monitor link groups
display monitor-link group
{ group-id | all }
Available in any view.
Monitor Link Configuration Example
Implementing Collaboration Between Smart Link and Monitor Link
Network requirements
As shown in Figure 2-3, the PCs access the server and Internet through the switch. Configure Smart
Link and Monitor Link to prevent the PCs from failing to access the server and Internet due to uplink link
or port failure.
To Next Page
Loading...
