1-3
To do… Use the command… Remarks
Set system information, and specify
to enable SNMPv1 or SNMPv2c on
the switch
snmp-agent sys-info
{ contact sys-contact |
location sys-location |
version { { v1 | v2c | v3 }* |
all } }
Required
By default, the contact
information for system
maintenance is " 3Com
Corporation.", the system
location is " Marlborough,
MA 01752 USA ", and the
SNMP version is SNMPv3.
Direct
configura
tion
Set a
community
name
snmp-agent community
{ read | write }
community-name [ acl
acl-number | mib-view
view-name ]*
Set an
SNMP
group
snmp-agent group { v1 |
v2c } group-name [ read-view
read-view ] [ write-view
write-view ] [ notify-view
notify-view ] [ acl acl-number ]
Set a
community
name and
access
permission
Indirect
configura
tion
Add a user
to an
SNMP
group
snmp-agent usm-user { v1 |
v2c } user-name group-name
[ acl acl-number ]
Required
z You can set an
SNMPv1/SNMPv2c
community name
through direct
configuration.
z Indirect configuration is
compatible with
SNMPv3. The added
user is equal to the
community name for
SNMPv1 and
SNMPv2c.
z You can choose either
of them as needed.
Set the maximum size of an SNMP
packet for SNMP agent to receive or
send
snmp-agent packet
max-size byte-count
Optional
1,500 bytes by default.
Set the device engine ID
snmp-agent local-engineid
engineid
Optional
By default, the device
engine ID is “enterprise
number + device
information”.
Create/Update the view information
snmp-agent mib-view
{ included | excluded }
view-name oid-tree [ mask
mask-value ]
Optional
By default, the view name
is ViewDefault and OID is
1.
Follow these steps to configure basic SNMP functions (SNMPv3):
To do… Use the command… Remarks
Enter system view
system-view
—
Enable SNMP agent
snmp-agent
Optional
Disabled by default.
You can enable SNMP agent by
executing this command or any
of the commands used to
configure SNMP agent.
To Next Page
Loading...
