1-7
To do… Use the command… Remarks
dir [ remotefile ] [ localfile ]
Query a specified file on the
FTP server
ls [ remotefile ] [ localfile ]
Optional
If no file name is specified, all
the files in the current directory
are displayed.
The difference between these
two commands is that the dir
command can display the file
name, directory as well as file
attributes; while the Is
command can display only the
file name and directory.
Download a remote file from
the FTP server
get remotefile [ localfile ]
Upload a local file to the remote
FTP server
put localfile [ remotefile ]
Rename a file on the remote
server
rename remote-source
remote-dest
Log in with the specified user
name and password
user username [ password ]
Connect to a remote FTP
server
open { ip-address |
server-name } [ port ]
disconnect
Terminate the current FTP
connection without exiting FTP
client view
close
quit
Terminate the current FTP
connection and return to user
view
bye
Display the online help about a
specified command concerning
FTP
remotehelp
[ protocol-command ]
Optional
Enable the verbose function
verbose
Optional
Enabled by default.
Specifying the source interface and source IP address for an FTP client
You can specify the source interface and source IP address for a switch acting as an FTP client, so that
it can connect to a remote FTP server.
Follow these steps to specify the source interface and source IP address for an FTP client:
To do… Use the command… Remarks
Specify the source interface
used for the current connection
ftp { cluster | remote-server }
source-interface
interface-type interface-number
Optional
Specify the source IP address
used for the current connection
ftp { cluster | remote-server }
source-ip ip-address
Optional
Enter system view
system-view
—
To Next Page
Loading...
