1-18
2001::20F:E2FF:FE00:1, subnet is 2001::/64
3001::2, subnet is 3001::/64
Joined group address(es):
FF02::1:FF00:2
FF02::1:FF00:1
FF02::1
MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 1
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
# On Switch A, ping the link-local address, EUI-64 address, and global unicast address of Switch B. If
the configurations are correct, the above three types of IPv6 addresses can be pinged.
When you use the ping ipv6 command to verify the reachability of the destination, you must specify the
“–i” keyword if the destination address is a link-local address. For the operation of IPv6 ping, refer to
section
IPv6 Ping.
[SwitchA-Vlan-interface2] ping ipv6 FE80::20F:E2FF:FE00:1 -i Vlan-interface 2
PING FE80::20F:E2FF:FE00:1 : 56 data bytes, press CTRL_C to break
Reply from FE80::20F:E2FF:FE00:1
bytes=56 Sequence=1 hop limit=255 time = 80 ms
Reply from FE80::20F:E2FF:FE00:1
bytes=56 Sequence=2 hop limit=255 time = 60 ms
Reply from FE80::20F:E2FF:FE00:1
bytes=56 Sequence=3 hop limit=255 time = 60 ms
Reply from FE80::20F:E2FF:FE00:1
bytes=56 Sequence=4 hop limit=255 time = 70 ms
Reply from FE80::20F:E2FF:FE00:1
bytes=56 Sequence=5 hop limit=255 time = 60 ms
--- FE80::20F:E2FF:FE00:1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 60/66/80 ms
[SwitchA-Vlan-interface2] ping ipv6 2001::20F:E2FF:FE00:1
PING 2001::20F:E2FF:FE00:1 : 56 data bytes, press CTRL_C to break
Reply from 2001::20F:E2FF:FE00:1
bytes=56 Sequence=1 hop limit=255 time = 40 ms
Reply from 2001::20F:E2FF:FE00:1
bytes=56 Sequence=2 hop limit=255 time = 70 ms
Reply from 2001::20F:E2FF:FE00:1
To Next Page
Loading...
