1-5
The default gateways for the three hosts A, B and C are 1.1.2.3, 1.1.6.1 and 1.1.3.1 respectively. The
configuration procedure is omitted.
4) Display the configuration.
# Display the IP routing table of Switch A.
[SwitchA] display ip routing-table
Routing Table: public net
Destination/Mask Protocol Pre Cost Nexthop Interface
0.0.0.0/0 STATIC 60 0 1.1.4.2 Vlan-interface500
1.1.2.0/24 DIRECT 0 0 1.1.2.3 Vlan-interface300
1.1.2.3/32 DIRECT 0 0 127.0.0.1 InLoopBack0
1.1.4.0/30 DIRECT 0 0 1.1.4.1 Vlan-interface500
1.1.4.1/32 DIRECT 0 0 127.0.0.1 InLoopBack0
127.0.0.0/8 DIRECT 0 0 127.0.0.1 InLoopBack0
127.0.0.1/32 DIRECT 0 0 127.0.0.1 InLoopBack0
# Display the IP routing table of Switch B.
[SwitchB] display ip routing-table
Routing Table: public net
Destination/Mask Protocol Pre Cost Nexthop Interface
1.1.2.0/24 STATIC 60 0 1.1.4.1 Vlan-interface500
1.1.3.0/24 STATIC 60 0 1.1.5.6 Vlan-interface600
1.1.4.0/30 DIRECT 0 0 1.1.4.2 Vlan-interface500
1.1.4.2/32 DIRECT 0 0 127.0.0.1 InLoopBack0
1.1.5.4/30 DIRECT 0 0 1.1.5.5 Vlan-interface600
1.1.5.5/32 DIRECT 0 0 127.0.0.1 InLoopBack0
127.0.0.0/8 DIRECT 0 0 127.0.0.1 InLoopBack0
127.0.0.1/32 DIRECT 0 0 127.0.0.1 InLoopBack0
1.1.6.0/24 DIRECT 0 0 192.168.1.47 Vlan-interface100
1.1.6.1/32 DIRECT 0 0 127.0.0.1 InLoopBack0
To Next Page
Loading...
