4
CONFIGURING THE
3C509B NIC
This chapter describes how to configure the 3C509B NIC,
reconfigure the NIC, and change configuration settings.
Configuring the 3C509B NIC
This section describes how to configure the 3C509B NIC.
If you have only one 3C509B NIC installed and you are
running Novell NetWare, use the AutoLink program to
configure the NIC and load the necessary driver, as
described in Chapter 3.
To configure the 3C509B NIC, follow these steps:
1 Install the NIC and network driver, as described in
Chapters 2 and 3.
2 Reboot your PC using a DOS diskette.
3 Put the EtherDisk diskette in floppy drive A.
4 To run the Install program, type:
a:install [Enter]
This opens the main menu shown in Figure 3-1.
5 From the main menu, select Configuration and
Diagnostic Program.
If necessary, select the NIC you want to configure. Tab to
the Select button and press [Enter].
6 Select Configure NIC and press [Enter].
This opens the NIC Configuration screen shown in
Figure 4-1.
To Next Page
Loading...
Need help?
General
