3D Systems, Inc.
4. Place the entire basket in a 70°C (158°F) oven for 30
minutes or until the wax support material has melted off.
NOTE: Ensure you set the basket on top of a drip tray
to allow support material to drip off into the tray.
5. Remove parts from oven and wipe off any remaining support
material with a lint free paper towel.
6. Place parts in a clean warm mineral bath (approx. 65°C
(149°F) ) for 30 minutes.
7. After 30 minutes wipe parts dry and they are ready to use.
22
To Next Page
Loading...
