3M Clean-Trace NGi Luminometer User Manual

The 3M™ Clean-Trace™ NGi Luminometer will now perform an
initial background and calibration check.
If the initial background and calibration check are within limits, the
screen on the right will be displayed.
Should the initial background measurement fail, see the
troubleshooting guide in Section 10 of this manual.
Pressing the OK button will display the main system menu.
Should the 3M™ Clean-Trace™ NGi Luminometer fail the startup self check, one of several screens may be
displayed. If this occurs, see the troubleshooting guide in section 10 of this manual.
2.05 Measurement Modes
The 3M™ Clean-Trace™ NGi Luminometer instrument offers three ways to measure a sample.
MEASURE SAMPLE allows as many readings as required, but does not store the data for later use. If the 3M™
Clean-Trace™ Luminometer Printer is used, results may be printed as they are produced as long as the 3M™
Clean-Trace™ NGi Luminometer is located in its docking station and connected to the printer. (see section 4 for
further details)
PROGRAM MODE allows data to be saved on the 3M™ Clean-Trace™ NGi Luminometer and then transferred to
the 3M™ Clean-Trace™ Online Software. To use the Program Mode, sample plans will need to have been
created and downloaded to the 3M™ Clean-Trace™ NGi Luminometer. (see section 5 for further details).

3M Clean-Trace NGi Luminometer Specifications

General

Brand	3M
Model	Clean-Trace NGi Luminometer
Category	Measuring Instruments
Language	English