EasyManua.ls Logo

3M Clean-Trace NGi Luminometer - Regulatory Compliance; Environmental Operating Conditions

3M Clean-Trace NGi Luminometer
42 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
do not store or use the 3M™ Clean-Trace™ Luminometer, Power Supply, or Docking Station in a location
exposed to steam high humidity, dust or strong vibration.
Ensure that the battery charger power supply connector is in the right orientation before inserting into
luminometer. If oriented properly, it connects easily, do not use excessive force when connecting.
REGULATORY COMPLIANCE
The CE Mark denotes compliance of the Clean Trace NG Luminometer with the following European Directives
Electromagnetic Compatibility as set out in the EMC Directive 2004/108/EC and
Electrical Safety as set out in the Low Voltage Directive 2006/95/EC.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.
This Class (A) digital apparatus complies with Canadian ICES-003.
ENVIRONMENTAL OPERATING CONDITIONS
Environmental Condition Operating Condition Units
Altitude Not limited metres
Operating Temperature Range +15 to +35 (+59 to +95) °C (°F)
Relative Humidity 10 - 90 (Non-condensing) %
AC Voltage (US/Canada) 120 Volts
AC Voltage (Europe) 230 Volts
AC Voltage (Japan) 100 Volts
Frequency 50/60 Hertz
AC Current (US/Canada) 190 m A
AC Current (Europe) 110 m A
AC Current (Japan) 230 m A

Related product manuals