5.0 PROGRAM MODE
5.01 What is PROGRAM MODE and how do I use it
5.02 How to Use Program Mode
5.03 Retesting
5.04 Reviewing results
5.05 Printing results
5.01 What is Program Mode and how do I use it
The PROGRAM MODE of the 3M™ Clean-Trace™ NGi Luminometer is used to carry out testing and save results
against specific test points within a saved sample plan. Refer to the 3M™ Clean-Trace™ Online Software User
Guide to download the service driver to allow communication between 3M™ Clean-Trace™ Online Software and
the 3M™ Clean-Trace™ NGi Luminometer via the USB connection.:
1. Ensure the 3M™ Clean-Trace™ NGi Luminometer is connected to the PC via the USB cable or 3M™ Clean-
Trace™ NG Luminometer Docking Station.
2. Create a sample plan using the 3M™ Clean-Trace™ Online Software.
3. Transfer the sample plan from the 3M™ Clean-Trace™ Online Software to the 3M™ Clean-Trace™ NGi
Luminometer.
4. Transfer stored results from the 3M™ Clean-Trace™ NGi Luminometer to the 3M™ Clean-Trace™ Online
Software.
Once the sample plans have been transferred to the 3M™ Clean-Trace™ NGi Luminometer, it is ready to take
measurements.
5.02 How to Use Program Mode
From the MAIN MENU, use the navigation (
▲/▼)
buttons to
highlight PROGRAM MODE and press Select
The PROGRAM MODE menu will display the current list of
sample plans as shown on the right. Use the navigation (▲/▼)
buttons to highlight the required sample plan and press Select
At this point it is possible to use the 3M™ Clean-Trace™ NGi Luminometer to perform a new series of tests for the
selected sample plan, or to perform retests on existing stored results which are shown in date order on the screen.
To Next Page
Loading...
Need help?
General
