To measure another sample, remove the previous test, insert the
next one and press the Measure key.
When all measurements are completed press the Back key to
return to MAIN MENU.
If the light in the chamber exceeds the range of the instrument,
an Overload message will be displayed.
Press any key to continue.
Overloads occur if the rate of rise of the RLU units exceeds a pre-determined factory set rate. Accidental overload
results may occur, e.g. if the sample chamber is opened while a measurement takes place. In the case of an
overload a repeat measurement can be made once the cause has been found.
To Next Page
Loading...
