To complete the login process, the ENTER PASSWORD screen
is displayed. To enter the password, use the navigation
(▲/▼/◄/►) buttons to choose each character and press Select
to enter that character. Repeat until the full password has been
entered and press Done.
When the ENTER PASSWORD screen is displayed, the user also
has the option to Change Password. The user can select this
option before entering the current password. Select the Change
Password function using the navigation (▲/▼) buttons and press
Select.
The user is prompted to Enter Current Password. To enter the
password, use the navigation (▲/▼/◄/►) buttons to choose each
character and press Select to enter that character. Repeat until
the full password has been entered and press Done. The Enter
New Password screen is then displayed, followed by Confirm
New Password. Both screens are completed as described
above, selecting Done when finished.
Note: Passwords must contain at least 8 characters a
combination of at least 3 of the 4 following types of characters:
• Upper case letters
• Lower case letters
• Digits
• Special characters
Refer to the Troubleshooting Section of this Instruction Manual or
the 3M™ Clean-Trace™ Online Software User Guide, if there
are difficulties at the login and password stages.
To Next Page
Loading...
