3M Steri-Vac GS Series - Printer Form Feed; Cycle Categories; Operator Cycles

20
3M
™
Steri-Vac
™
Sterilizer /Aerator GSSeries – Operator’sManual
10.3.4. Printer FormFeed
The Printer Form Feed button advances the printer paper by approximately 5cm (2in.). Figure 16details the location of the Printer Form Feedbutton.
Sterilizer
22.2
˚
C
98.0
kPa
Select cycle temperature:
04/20/2015
05:19:53
65432
1
7
Reports
Cycles
Setup
Status
Service
Cycle reports
EO usage report
Site setup report
Printer form feed
55 °C
Figure16.
Location of the Printer Form
F
eedButton
10.4. CycleCategories
There are two categories of cycles: standard Operator Cycles and specialized Supervisor Cycles. Figure 17shows the Cycles Options Menu - OperatorCycles.
10.4.1. OperatorCycles
Selecting Operator Cycles allows the Operator Cycles to appear on the Main screen (Figure17).
Sterilizer
22.2
Select cycle temperature:
˚
C
04/20/2015
05:19:54
65432
1
7
98.0
kPa
Reports
Cycles
Setup
Status
Service
Operator cycles
Supervisor cycles
55 °C
Figure17.
Cycle Options Menu - OperatorCycles