Aprisa SRx User Manual 1.3.0
Single Radio Software Upgrade
The software upgrade procedure is different for an Aprisa SR Protected Station.
Note: If a radio has been configured for a Protection Type of ‘Redundant’, and that radio is no longer part
of a Protected Station, the Protection Type must be changed to ‘None’ before the radio software upgrade
can be achieved.
File Transfer Method
This process allows customers to upgrade a single Aprisa SR radio.
The Software Pack is loaded into the radio with the file transfer process (see ‘Software > File Transfer’ on
page 181) and activated (see ‘Software > Manager’ on page 184).
Upgrade Process
The Aprisa SR upgrade operation is indicated by a flashing orange MODE LED.
To upgrade the Aprisa SR radio software:
1. Unzip the software release files in to the root directory of a USB flash drive.
2. Check that the SuperVisor USB Boot Upgrade setting is set to ‘Disabled’ (see ‘Software > Setup’ on
page 180).
3. Insert the USB flash drive into the host port .
4. Using File Transfer, load the software pack into the radio (see ‘Software > File Transfer’ on page 181).
5. Activate the software on the radio (see ‘Software > Manager’ on page 184).
To Next Page
Loading...
